Monroe-electronics 988 Manuel d'utilisateur

1 Instruction Manual EAS DIGITAL/ANALOG OVERRIDE INTERFACE Model 988 PC Software version 1.06 Emergency Alert Syst

10 Firmware Version Display the firmware version in the 988. Firmware Update Downloads the firmware to the 988. This is for future updates. You

11 To Set Date & Time (GMT Greenwich Mean Time) All EAS alerts are encoded using GMT or UTC. First verify that the time and date on your compu

12 Add FIPS code On the main screen click the Add FIPS button to open the following window. These will be the available FIPS codes to be used when

13 Storing The Setup to the Unit Click on the Store to 988 button to send and store the setup to the 988 unit. Programming is now co

14 Installation Connect the telephone cable to the RJ-11 plug, two wires for balanced audio from the screw terminals marked AFSK/AUDIO to the balanc

15 Operation Monroe Model 988 interfaces a two-wire (POTS) telephone service with control switching and audio control signals to an FCC approved e

16 988 Activation Instructions for Local Authorities 1. Dial the phone number of the line connected to the 988. 2. The unit will prompt you w

17 Refer to the picture below for locations of the gain controls, record switch, microphone and wiring.

18 Wiring Diagrams

19

2 Table of Contents Warranty 3 Specifications 4 General Overview 5 Getting Started 6 -13 Installation

3 Warranty Monroe Electronics, Inc. warrants to the owners, each instrument and sub-assembly manufactured by them to be free from defects in materi

4 Specifications Number of rings before answer 1 to 8 Automatic time out 1 minute with no or incorrect activities Access code selection Any thre

5 General Overview Some EAS decoder/encoders have no installed or available provision for local access to the emergency alert system in place in th

6 Getting Started The following “Getting Started” steps are programming functions that must be accomplished before installing your 988. Please refe

7 Select the CD-ROM drive, and then click Next. Click Next again. Click Finish. Windows may repeat the process

8 Installing the 988 Setup software Insert the 988 CD into your computer. The following screen will come up. Click on Installation. Click o

9 Running the 988 Setup program Click on the 988 icon on your desktop to start the program. It will first ask for the comport connection to the 988’