Monroe-electronics R190A Manuel d'utilisateur

Instruction Manual LAN Hub Controller Model R190A Monroe Electronics 100 Housel Ave Lyndonville NY 14098-0535 800

Section 1 EAS 8 Changing the IP address – Type the new IP address into the boxes following “IP address” shown above. To upload the address

Section 1 EAS 9Password Settings – The R190A allows you to program a Setup and a Control password. The unit is defaulted with a Setup passwo

Section 1 EAS 10Operation Testing the unit can be done by accessing the unit in the same manner it was programmed. Enter the unit’s IP add

Section 1 EAS 11To configure your R189 One-Net EAS Encoder/Decoder to talk the R190A, refer to section 5.10 of the R189 Manual for programmin

12 SECTION 2 REMOTE CONTROL

Section 2 Remote Control 13General Remote Control Overview In its basic configuration, the R190A is a simple remote control that allows the

Section 2 Remote Control 14Remote Control Getting Started Setting the IP address-- Setting the IP address for remote control applications i

Section 2 Remote Control 15 Click NETWORK to change the IP address.

Section 2 Remote Control 16 Changing the IP address – Type the new IP address into the boxes following “IP address” shown above. To upload

Section 2 Remote Control 17Password Settings – The R190A allows you to program a Setup and a Control password. The unit is defaulted with a

Table of Contents Warranty 1 Specifications 2 Front and Rear View 3 SECTION 1 EAS - R190A being controlled by the R189 One-Ne

Section 2 Remote Control 18Relay Configuration From the main menu, click the Relay 1 tab to setup how the relay 1 section of the control pag

Section 2 Remote Control 19OPERATION Operating the unit can be done by accessing the unit in the same manner it was programmed. Enter the u

Section 2 Remote Control 20Applications The R190A can control any device within the power limits of its relay contacts. Adding a power relay

1 Warranty Monroe Electronics, Inc. warrants to the owners, each instrument and sub-assembly manufactured by them to be free from defects in materi

2 Specifications Number of relays 4 Individually controlled rated for 1Amp at 28 Volts DC, SPDT, NO, NC. Latch ON, Latch OFF, and Momentary fro

3 Front View Rear View

Section 1 EAS 4General EAS Overview The R190A Hub Controller provides the ability to switch equipment at a remote site or CATV Hub during E

Section 1 EAS 5EAS Getting Started Setting the IP address – The R190A comes with a default IP address of 192.168.1.2. One of the following

Section 1 EAS 6Setup Configuration – The Setup mode of the R190A allows you customize several settings. Some of the settings are the unit’s

Section 1 EAS 7