Monroe-electronics Electrostatic Voltmeter - Isoprobe® - model 279L Manuel d'utilisateur télécharger pdf (Page 22)

279L-0401-RCA Page 19

Fuse changing:

Figure A-II-3a

European fusing arrangement

Figure A-II-3b

North American fusing arrangement

Figure A-II-4

Fuse block/cover assembly

To change from North American to European fusing: open cover using a small blade screwdriver or similar tool;

loosen Phillips screw 2 turns; remove fuse block by sliding up, then away from Phillips screw and lifting up from

pedestal; change fuses (note that

two European fuses are required, although a dummy fuse may be used in the

neutral [lower] holder); invert fuse block and slide back onto Phillips screw and pedestal; tighten Phillips screw and

replace cover (note that the fuse[s] that go into the housing first are the active set.)

See SPECIFICATIONS for recommended fuses.

1 2 ... 17 18 19 20 21 22 23 24

Pas de commentaire

Monroe-electronics Electrostatic Voltmeter - Isoprobe® - model 279L Manuel d'utilisateur Page 22