Monroe-electronics R189se Manuel d'utilisateur télécharger pdf (Page 11)

- 6 -

 Every line input supports two (2) EAS decoders. The left side of the input is decoded

separately from the right side. So two line inputs provide four (4) EAS decoders.

 EAS alerts are selectively played out of the analog line output ports. Software is used to

select which ports are used for alert origination and forwarding.

 The main microphone input is used to record EAS audio messages.

For decoding, each side of the stereo input of any audio input can be selectively used as a

single decoder source. In other words, one stereo input supports two EAS decoders. A dual

RCA to 3.5 mm jack input adapter can be used to connect two separate mono input signals to

a One-Net

line input jack.

For alert encoding an audio cable is run from a software-selected 3.5 mm line output jack

into your systems alert audio wiring. Only analog audio output is supported.

2.5 Video Wiring

The video output provides an NTSC analog composite video signal through the yellow RCA

jack. This will provide a details page during alert forwarding and/or alert origination.

2.6 GPIO Output relays

The One-Net

provides two General Purpose Output relays and two General Purpose inputs.

During an alert origination or forwarding, the GPO relay 1 is closed for the duration of the

alert audio portion of the alert, and GPO relay 2 can be programmed to close during the audio

or video portion of the alert.

2.7 MPEG Encoder Card Wiring

For One-Nets equipped with the optional MPEG2 Encoder card, see the illustration below for

wiring the MPEG2. The video output needs to be loop cabled back into the video input of the

Encoder card. Likewise, one audio output needs to be cabled to the MPEG audio input port.

Optional MPEG2 PCI Encoder Card Audio/Video connections

NOTE: The SPDIF digital audio output port is not used.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 113 114

Pas de commentaire

Monroe-electronics R189se Manuel d'utilisateur Page 11