Monroe-electronics R189se Manuel d'utilisateur télécharger pdf (Page 59)

- 54 -

Automatic Required Weekly Test to occur by changing the between times, and the

On Days followed by clicking the Accept Time Changes button.

Configure One-Button and Automatic Weekly Test.

 Set FIPS locations for and Duration of the weekly test.

 Select a FIPS location(s), and then click Add Selected FIPS.

 The FIPS location(s) added will appear in the list of Current FIPS locations for

One-Button Weekly Test to the right.

 You can edit the subdivision in the first field for each location.

 You can remove a FIPS location from the list-using Remove.

 You can Enable/Disable the front panel button activation of a Weekly Test.

4.10 Setup > Net Alerts

One of the benefits of the One-Net’s inherent network nature is that it can support a variety

of methods for network forwarding/broadcast of EAS alerts. Presently the One-Net

supports DVS-168 network protocol, DVS-644/SCTE-18 alert messaging, Streaming Mpeg,

and Remote activation of relays using the Hub Controller Model R190A. If interfaces are not

available, follow the link to License Key Manager to Setup > Server (see section 5.1). Select

one of the protocols for editing by using the provided tabs at the top of the Net Alerts

Configuration page. A separate interface is provided per Network protocol interface type.

There are four tabbed sub-pages on the Setup Net Alerts screen. They are:

EAS NET

CAP Decode DVS664 (SCTE 18) Net CG Hub Controller

4.10.1 DVS168

If DVS-168 is available on the One-NetSE, use this tab to enable this protocol for

forwarding and/or sending alerts.

Setup > Net Alerts > DVS168

Alert Forwarding to DVS168/EARS device.

Placing a check in this box will allow Alerts that are received from a Broadcaster to

be forwarded through the One-Net

and sent out using the DVS168 protocol.

Encoder Alert Send to DVS168/EARS device.

Placing a check in this box will allow Alerts that are originated by the One-Net

be sent out using the DVS168 protocol.

Alert Forwarding and sending to DVS168/EARS Client

Once forwarding and/or sending have been enabled, four information fields must be

configured to identify the DVS-168/EARS host. See the provided screenshot. Enter the IP

address, the IP port, the FTP user and password, select Audio File Sample Size, and the

Audio File Sample Rate (Default is 16000 Sample/sec). Alerts with all FIPS codes can

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 113 114

Pas de commentaire

Monroe-electronics R189se Manuel d'utilisateur Page 59