Monroe-electronics R190A Manuel d'utilisateur télécharger pdf (Page 12)

Section 1 EAS

Operation

Testing the unit can be done by accessing the unit in the same manner it was

programmed. Enter the unit’s IP address into your browser and the following

display will be shown. Triggering any of the four relays can be done in either a

latching mode or Pulse. Clicking on the button, On, Off, or Pulse, on the desired

relay will allow you to test that the device being controlled by the R190A is

functioning properly. The color of the relay status will change from red to green

when the relay is closed.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 21 22

Pas de commentaire

Monroe-electronics R190A Manuel d'utilisateur Page 12