Monroe-electronics R190A Manuel d'utilisateur télécharger pdf (Page 19)

Section 2 Remote Control

Password Settings – The R190A allows you to program a Setup and a Control

password. The unit is defaulted with a Setup password of “monroe”, and the

Operation password is disabled. If changes are made to either the Setup or the

Operation password, you must click on the “Submit” button to store the change.

Passwords may be up to 10 characters in length. If the passwords are forgotten,

the R190A can be set back to factory defaults by removing the power from the unit,

pressing and holding the Reset button on the back of the unit, and reconnecting

the power to the unit. After approximately 10 seconds you can release the Reset

button and the unit will be set back to the default password of “monroe” for the

Setup and no password for the Control. Caution: Pressing the reset switch will

reset ALL user settings back to default. This includes network IP address and

associated settings.

1 2 ... 14 15 16 17 18 19 20 21 22

Pas de commentaire

Monroe-electronics R190A Manuel d'utilisateur Page 19