Monroe-electronics R190A Manuel d'utilisateur télécharger pdf (Page 16)

Section 2 Remote Control

Remote Control Getting Started

Setting the IP address-- Setting the IP address for remote control applications is

identical to the procedure used for EAS applications. Follow the steps in the EAS

Getting Started section to set the device IP address for your network.

Setup Configuration – The Setup mode of the R190A allows you customize

several settings. Some of the settings are the unit’s IP address, Netmask,

Gateway, network speed, mode and passwords. There is no user name required

to log into the Setup, and the default password is shown in bold between the

quotes “monroe”. The following screenshots show the setup pages.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 22

Pas de commentaire

Monroe-electronics R190A Manuel d'utilisateur Page 16