Monroe-electronics R189se Manuel d'utilisateur télécharger pdf (Page 41)

- 36 -

To test the Main and/or Auxiliary Audio outputs, attach speakers to the One-Net

audio

device output ports and run the various tone test buttons. The Front Panel Speaker can be

tested as is. These tests allow the One-Net

to play each of the two single tones that

comprise the dual-tone EAS Attention Signal. The EAS Attention signal and WAV files

can also be played. The duration of the test is set per Audio device by the Test Tone

Duration fields.

Audio tests, audio levels and duration changes occur immediately.

Alert Audio Toggles

The Main and Auxiliary Audio displays also display with an active hyperlink if alert

audio from originated and forwarded alerts is enabled. Clicking these links will jump to

the correct Decoder and Encoder Audio setup page for changes to be made.

Upload Audio .WAV file to One-Net

Server

This interface allows Wav files to be uploaded into the One-Net

. Uploaded audio files

are available for tests as well as for encoding and manual forwarding.

4.6.2 Radio Tuners

The One-Net

can be equipped with up to three internal radio tuners. Each tuner can be

configured by the user, through the browser page, to receive AM, FM or NOAA stations.

Setting the Radio Types and Frequencies:

Use this screen to program the installed radios. For each radio select the radio type by

clicking on the button to the left of each type. Next, click on the frequency box and type

in the desired frequency for an approved radio station and click on the Accept Typed

Frequency Change button to accept the change. This frequency MUST correspond to an

approved LP1 or LP2 for your area. You can obtain a list of approved stations from the

EAS Chairman of your state. Repeat this process for all of the installed radios.

After setting all of the radios, verify that level is OK. This is displayed to the right of the

frequency box. To listen to the radio signal, you can select where to route the signal to

clicking on the appropriate button. In most cases the audio is routed to the front panel

speaker. Make sure to turn off the feature when done testing.

NOTE: The interface pages for Decoder and Encoder Audio display

and reference audio output levels for certain features. These references

always provide an active hyperlink into this page to allow for changes

to audio out

ut levels.

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 113 114

Pas de commentaire

Monroe-electronics R189se Manuel d'utilisateur Page 41