Monroe-electronics R189se Manuel d'utilisateur Page 48

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 114
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 47
- 43 -
set the exact video duration in minutes and seconds. A set of details pages will be played
out of the RCA video output port on the back of the One-Net
SE
.
Alternating Video page durations in seconds
This value determines how long each video page is displayed if the EAS message is more
than one page long.
Video Page color, Font size, and Font name
Allows you to customize the page color, font, and font size of the NTSC video settings to
your liking.
Serial controlled video duration
Check this box to display the Internal CG video message as long as serial controlled CG
is active.
Optional Duration Extension Time
Entering a time in a mins:secs format will extend the time that the details video message
is displayed. The maximum setting is 1 hr.
EAS Translation Language Options
There are three translation options. They are English, English and Spanish, and Spanish.
Click Accept Changes to make changes apply.
4.8 Setup > Decoder
By default, a One-Net
SE
will run two EAS decoder channels from the Main audio device. It
will decode EAS out of the box. However, a variety of useful options can be configured to
tune the decoder for operation in a specific system within a specific geographic region. All
decoder configuration options can be accessed through the Setup > Decoder page.
4.8.1 Setup Decoder > Forwarding
The Decoder Forwarding page is used to configure EAS alert forwarding. Forwarding is
when a decoded EAS is relayed out an audio output of the One-Net
SE
, presumably into a
broadcast audio signal, and display a video message out of the serial port controlled
character generator and One-Net
SE
video output. Forwarding can be automatic or manual.
Forwarding can be set so that all alerts to any FIPS area are forwarded, or it can be highly
constrained so that only a select few EAS codes to specific FIPS areas are forwarded. Use
this screen to configure station identity settings and to select EAS alerts that are
forwarded. To select the actual audio output port(s) for forwarded alerts, a different Web
Interface page is used see Setup Audio > Decoder Audio. Forwarded alerts are logged
on the Decoder > Forwarded Alerts display page.
Vue de la page 47
1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 113 114

Commentaires sur ces manuels

Pas de commentaire