Monroe-electronics R189se Manuel d'utilisateur télécharger pdf (Page 25)

- 20 -

Network Type > Static: Setting the IP address manually

To set a new static IP address, select Network Type > Static. Then fill in the values for

the desired IP address and Netmask. If needed, also select Use DNS and/or check for

addition of a default gateway route.

Setup > Network > Configuration: Set-up Static IP manually

Enter the corresponding values. The example shows a new IP address of 192.0.0.81 and a

Netmask of 255.255.255.0, as well as a DNS and gateway configuration. To set the new

values, select Accept Changes.

Once the new settings are accepted, the One-Net

will log you off. After a few seconds

wait, you can log back in on the redirected address on the Login page, as before.

IMPORTANT! You must be CAREFUL when configuring a static network address if

you are configuring from a remote host. If an address, which is inaccessible to your

network, is accepted for the One-Net

, you will be unable to log back in from the remote

host. If this happens to you accidentally or on purpose, you will have to directly login to

the One-Net

from a directly connected VGA monitor, keyboard and mouse. You can

always configure the One-Net

from this direct connection.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 113 114

Pas de commentaire

Monroe-electronics R189se Manuel d'utilisateur Page 25